Step 1: Clean
Remove all grease and dirt from the tiles with Selleys Sugar Soap. Repeat this process twice with clean water. Allow the tiles to dry.
Step 2: Repair
Assess the tiles for any loose and flaking paint or damage that needs to be repaired. Remove the flaking paint and fill any cracks or holes with a hard epoxy-based filler like Selleys Knead-It Aqua. Allow the filler to dry completely.
Step 3: Sand
Once the repaired areas are dry, sand the tiles to dull the glossy finish with 400 grit sandpaper. Use a clean, damp cloth to remove dust once the tiles are sanded.
Step 4: Mould Prevention
Next, thoroughly clean the tile surface with Selleys Rapid Mould Killer.
Expert Tip – Use a brush to ensure the mould killer cleans the tiles and the grout effectively.
Step 5: Remove Silicone
Remove all silicone sealant from joints using a silicone remover tool. For an easier time, use a sealant remover like Selleys Sealant Remover to break down and soften the old silicone before removing. Allow the grout line to dry fully before moving on.
Step 6: Mask
Mask the painting area with painter’s tape. Use masking film and drop sheets to protect any surfaces you won’t be painting such as the bath, vanity and floor. Allow the tiles and grout to dry completely before starting to paint.
Expert Tip – Keep the masking tape fanned out to catch any drips when painting.
Step 7: Prime
Mix the additive into the Dulux Renovation Range Primer and stir until the additive is completely mixed in. Then, using a brush, cut in the grout lines with the primer before rolling. We recommend using a mini roller for this project to ensure the tile surface has even coverage. Allow 4 hours drying time for the primer.
Step 8: Paint
As with the primer, mix the additive into the Dulux Renovation Range Tiles & Benchtops. Stir thoroughly until the additive is completely mixed in. Again, cut in the grout lines with a brush before rolling. Allow 8 hours drying time before applying the second coat.
Expert Tip – Once each section is coated, lay off by going over the surface with minimal pressure in the same direction with an unloaded roller. This will give you a smooth, professional finish. Do this after both coats of paint.
Step 9: Protect
Finally, apply 2 coats of Dulux Renovation Range Clear Coat Gloss to the tiles. Like with the previous steps, cut in before rolling and then lay off after each section is coated. Allow 8 hours drying time between coats.
Expert Tip - Wait 2 days for light use of the tiles, 7 days for general use. This will allow the paint to cure and prevent damaging the finish.
Refreshing your bathroom tiles is not only a great way to update one of the hardest working rooms in your home, but it’s the perfect way to keep it looking fresh and modern for years to come.